Help Center


Running Resilio Connect Agent On NAS Or Low-Profile Linux Devices


Resilio Connect Agent is capable of running on NAS devices as well as low-profile Linux devices. There are some peculiarities an administrator should be aware of when planning to run Resilio Agent on the above mentioned devices.

  1. Memory consumption.
    Resilio Agent consumes on average 1.5Kb of memory per file or folder it syncs. Adding folders with a large number of files may cause your device to run out of physical memory and work extremely slowly due to swapping data to HDD/flash storage.
  2. CPU consumption.
    Resilio keeps all folders you add to it up-to-date and consumes CPU to keep track of all changes made in a folder, as well as sends it to other peers over network. The actual CPU consumption depends on the amount of top-level folders connected as well as the number of peers syncing. While exact amount of folders and peers served depends on CPU power, as a rule of thumb, it is advised not to exceed 8-10 folders and 50 peers in total for Raspberry PI-class devices.
  3. File change notifications.
    Some devices may not support file change notifications soResilio Agent will notice changes only during rescan (10-minute period by default).
  4. Accessing files over Samba.
    It is not advised to access files in synced folders over Samba. Samba daemons are doing excessive caching and may lead to Resilio delivering only partially changed files.
  5. HDD power-saving mode.
    By default, Resilio re-checks all files every 10 minutes, with any changes made on other peers delivered as soon as detected. This will prevent your HDD on NAS from entering power-saving mode.
Was the article helpful? Yes / No, send feedback on article Thanks!


Please note that we won't mail you back. This is just purely feedback on the article above. If you need help from our Support Team, please use the "Contact Support" link at the top of the page.